|| Page 3 Start ||
A-A-1037B
Application for copies of ASTM standards should be addressed to ASTM, 1916 Race Street, Philadelphia, PA 19103.
3. SALIENT CHARACTERISTICS
3.1 Design. The wire fabric design, materials, mesh size, filament sizes and tolerances shall be in accordance with ASTM E437 Standard Specification for Industrial Wire Cloth And Screens’. Type I fabric dimensions shall conform with ASTM E437, Table 2 and Type II fabric dimensions shall conform with ASTM E437, Table 1.
3.2 Crimp type. The wire fabric shall be lock crimped at points of intersection (except mesh sizes too fine to effectively lock crimp are exempt from this requirement).
3.3 Edges. When fabric being offered is prone to edge ravening (due to mesh size or other characteristics), the fabric edges shall be selvaged or otherwise treated to prevent ravening.
3.4 Roll dimensions.
3.4.1 Length. The wire fabric shall be furnished in a roll with a minimum length of 100 feet.
3.4.2 Width. The roll shall be furnished in the following widths as specified: 16, 24, 30, 36, 40, or 48 inches.
3.5 Roll dimension tolerances.
3.5.1 Roll length. The stated length is minimum (minus 0, plus measured outside to outside) shall be as shown below:
Mesh sizes or Equivalent opening |
Tolerance in width (inches) |
5 mesh and coarser |
+ 1/4 |
6 to 50 mesh |
+ 1/8 |
Finer than 50 mesh |
+ 1/16 |
3.6 Continuity. The roll shall contain not more than three pieces, none of which shall be less than 10 feet in length.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business